Nonmetallic Surface Adhesive & Screw Magnetic Mount
$16.99
- Built-in neodymium rare earth magnet
- 2.25″ diameter 3M foam Adhesive backing easily attaches to any flat surface, such as aluminum, fiberglass, plastic, rubber, wood, etc.
- Use this mount to easily attach your device to your motorcycle/scooter, boat, kayak, atv, dashboard or any flat surface
- Optional – included tapping screw to better secure mount to certain surfaces – 3.5 x 16mm
- Built-in loop to attach device tether (sold separately)
- Preferred mount for kayak and water navigation use
Compatible with both Elite™ and Micro™ devicesOrder today, delivery by: 08/18/2022
michael.gaudig (verified owner) –
You can stick, bolt, screw, this thing anywhere.
If you have a flat surface this will mouth without a doubt.
(0) (0)
Nicholas Lyons (verified owner) –
Stuck this to my dash board to hold my device while I’m not using it. Holds it in place and makes it easily accessible when needed.
(0) (0)
Shannon (verified owner) –
Have this mounted to my truck toolbox, will be buying more soon to add to my other products and toys
(0) (0)
Toby Terry (verified owner) –
I used this to mount the GA to the side of my sleigh trailer. Very easy to use. I still didnt trust the magnet so I added a small wire wrapped around a screw for “just in case’.. Didnt want to lose this expensive thing.
(0) (0)
Andrew (verified owner) –
Strong magnet. Easy to use. Quality hardware and adhesive
(0) (0)
Brian Donovan (verified owner) –
I purchased the unit to mount my white/white fixture to a pole. The diameter and holding power are perfect for my purpose. It’s secure as heck!
(0) (0)
Frank CASHMAN (verified owner) –
This mount work great on the front of my Jetski. It gives me extra visibility and peace of mind when out late
(0) (0)
BlueKnight1600 (verified owner) –
As a retired LEO, and member of a law enforcement motorcycle club, we do a lot of group rides, charity runs, and even funeral escorts. I bought 6 of these units, and mounted them on various, non-painted, high visibility parts of my bike, because, I believe, you can’t have too many lights on a motorcycle, when safety is a major concern. The day I bought my first 2 units, I tested them by running them for 13 straight hours, in the fully lit configuration. After 13 hours, they were still running bright. I ran them all day, on my dining room table, until I went to bed at night. They have never gone dead on me yet. I just recharge them before each use, just to top off the charge. I also charged them 2 years ago, and didn’t use them at all last year, because of the virus, and 2 years later, they still have their full charge. And the true beauty of them is that there is no wiring, no permanent mounting. When I’m done with the run, I simply take them off, and stow them in my tail pack. Smaller than a pack of cigarettes, you can stick them in your pocket, if you choose. And the variety of different mounts is endless. I bought the rubber, magnetic mounts, with the 3M adhesive, that once you put them on, they’re not going anywhere. And the magnet strength on these units, and their mounts, is EXTREMELY strong…there is NO WAY these are blowing off the bike, until you pull them off, and you feel the strength of the magnet when you pull them off. I also bought the arm strap magnetic mounts as well, and just like their many other other mounts, the magnets are rock solid, and going nowhere. Waterproof, and flashing from ALL sides (beside the bottom, where it mounts), the added safety, and visibility, goes without saying. My only little gripe is that I bought a set of 6 Elite Series units, but had to go online to buy a carry case for the units, the extra mounts and instructions. My only suggestion to GA is to offer a hard case, with foam interior, for easy, protective, long term storage, or just for stowing in your pack, or patrol bag. Also a good place for GA to advertise is on the case. But these lights are great. However, they are much more effective at night, than in the daytime, but I use them on day runs anyway, when riding in large groups. The flashing lights are still and attention-getter, as opposed to having none at all. A definite thumbs-up on these cool safety devices….
(0) (0)
John J Wirth (verified owner) –
The mount works great. I attached mine to the bow of my native kayak. I did swap the provided screw with a stainless bolt and locking nut that would connect through the deck for extra security. The magnets hold super well and I have no fear of loosing my GA to waves that hit the bow
(0) (0)
Martin Allen (verified owner) –
Great product and went onto helmet perfectly. Adhesive really did the job and fastened well. Highly recommended if you need to put one on a construction helmet, Motorcycle helmet, or in my case, bicycle helmet. Very impressed with this product and may buy more to keep on hand.
(0) (0)
Jeffrey Yekel (verified owner) –
I wasn’t to sure of how the device would work. But I have to say I am very impressed of how well the device works. It works great and would recommend it to anyone. The lights are very bright.
(0) (0)
Alan Robidoux (verified owner) –
if you purchase any of guardian angel devices these things are a must, it seems like it will stick to any surface and hold then securely.
(0) (0)
Brian Heinz (verified owner) –
This makes it super easy to place your light on a dashboard for a blinking warning light. Very strong magnet
(0) (0)
John VanCamp (verified owner) –
I use this on my dashboard for extra warning if needed it’s durable and I recommend getting one
(0) (0)
C Siano (verified owner) –
This mount comes with a strong 3M adhesive pre-applied to the back. A single mounting screw can also be used down the middle. While the mount is a flexible rubber like material, it contains a powerful magnet so that once your light is attached, it isn’t going anywhere. The slots fit the cross pattern on the larger GA devices to prevent them from pivoting. This mount works well to attach the GA device to the plastic housing on my Snow Machine. The GA device is fantastic for aiming to the rear when I’m last in line. Far more visible than the taillight.
(0) (0)
GARY M YARBRO (verified owner) –
This works great for attaching the Red / Green light to the kayak. Money well spent for the light/mount combo.
(0) (0)
J.B. Jones III (verified owner) –
I got one to put on the front of my Kayak. It was easy to mount and works great with any of the Safety Lights. Again, I can not say it enough; it was easy to install and start using right away. I use it with the Red/Green Wearable Safety Light as Navigation lights in the early morning fog in Tampa Bay when on the rivers and flats. Gr8 solution for a Coast Guard requirement if one uses a motor with ones Yak. I have had no issues with said products and would recommend this a a simple solution to ones safety requirement.
(0) (0)
Matthew Satterlee-King (verified owner) –
I like that it was easy to install and very cost effective. I am a protection officer so I use my mount almost every night as do my crew.
(0) (0)
Don Roth (verified owner) –
Great accessories for my kayak l love it and great safety accessories
(0) (0)
R. Jay Phelps (verified owner) –
Have used it on my vehicle several times while running my K9 and it has assisted greatly
(0) (0)
jo coelho (verified owner) –
The only safety light you’d ever need. Used it after 2 days and you’d be surprised how many people slow down and move over…. absolutely love it !!!
(0) (0)
Jonathan Stewart (verified owner) –
Work great on any surface. just clean it good before installing.
(0) (0)
Doug Wilson (verified owner) –
The adhesive mount with screw is my ideal mount for my GA light. I use the light on this mount as a “chase light” on my truck when overlanding. Super strong magnet for light retention, I have never had an issue.
(0) (0)
Craig Collins (verified owner) –
The base works great, on my kayak! I don’t like to travel with my bow light on. The plate makes installation and removal a snap. The marine light that I purchased at the same time gives me both vessel requirements and area lighting. I highly recommend the product for any small vessel.
(0) (0)
Curtis Hall (verified owner) –
Solid wood surface mount with supplied screw. Super strong magnet just like any of the other mounts.
(0) (0)
Noman –
The base mount is perfect for the Wilderness Systems Commander!
(0) (0)
Adam R Yeager (verified owner) –
Great mount to use for a kayak. The Nonmetallic Surface Adhesive & Screw Magnetic Mount allows an easy way to attach the Guardian Angel Device to the front of my kayak when operating the kayak at night. I use this mount with the lanyard for extra security of my device.
(0) (0)
Mark Beckman (verified owner) –
Had a problem with the kayak light mount the 3M backing came off send a message informing them of the issue the replied with great timing and apologized and sent me a brand new replacement.
(0) (0)
Jeffrey Jackson (verified owner) –
The surface mount is perfect for attaching the Guardian Device to the front of my Hobie Kayak. Definitely won’t lose this off the boat while out on the water.
(0) (0)
Charles Wilkerson Jr. (verified owner) –
I bought this mount thinking I would need a better way to mount the Guardian Angle light to my kayak. The magnet was strong enough without having to use this. I will find a use for it on one of the older kayaks.
(0) (0)
Daniel Martin (verified owner) –
This is the one mount that I have not gotten a chance to use yet. Just not sure what I want to mount it to yet. But the magnet holds strong like the others do
(0) (0)
Kevin Brown (verified owner) –
Much better than the stock one which had to be in the hull to mount it, as this one can be mounted on top giving a stronger hold.
(0) (0)
Gregory Wise (verified owner) –
Works very well on the collapsible cones I have using the adhesive backing. Keeps the lights held firm and at a perfect height.
(0) (0)
john.obrien.j (verified owner) –
I use this mount on my motorbike for marshalling. I have one on the front mudguard and one on the back box. Whatever speed I am travelling or the type of road the guardian angels stay secure on the mount. I have a red and white for the front and a red for the back. Both are very visible and make marshalling much safer
(0) (0)
John o brien (verified owner) –
I got two guardian angel units for bike marshalling. I use them on my motorbike attached with the boat marine outdoor base. I have one on the front mudguard and one on the back box. They are very solid and sturdy and whatever speed I am doing both units stay firmly attached with the magnets. I travel a lot of bumpy roads and no problem. Great units great accessories and a great service
(0) (0)
Joseph GIGLIO (verified owner) –
Product is easy to mount and magnet is strong. Great for kayak.
(0) (0)